1, the use of pneumatic diaphragm pump process is best not to exceed the recommended use of pressure, because the output pressure is equal to the supply of compressed air pressure, plastic material supply pressure should not exceed 7bar, although the metal material is more solid, but not more than 9bar. In fact, this point we look at the working principle of pneumatic diaphragm pump is not difficult to understand the truth.

2, if the transmission of dangerous media, be sure to wear protective clothing with good protective glasses.

3, before starting to ensure that the compressed air clean, so start before the first compressed air system should be cleaned, and to confirm in advance open valve, pressure regulator, pressure relief valve and other instruments work properly.

4, if the maintenance and repair, you must first ensure that the pressure inside the diaphragm has been completely vented, so turn off the compressed air, detach the gas pipeline.

5, in order to ensure safety, so the pneumatic diaphragm pump in the operation, the presence of any part of the body of the body do not close to the pump exhaust.

6, in order to ensure that the diaphragm pump has enough pressure, it can not use the leaked, has been corroded or faulty.

7, pneumatic diaphragm pump is compressed air as the power source, it is not free to use other compressed gas without detection, the only way to ensure safety.

8, diaphragm pump to use the appropriate medium, if you are not sure whether the medium with the diaphragm pump, please contact the diaphragm pump manufacturers, or will cause serious consequences.

9, the use of the process to ensure that the work within the specified temperature.

10, diaphragm pump manufacturers to pay special attention to the plastic material of the diaphragm pump, because the media and the pump will produce static electricity in the friction, the use of plastic parts in the plastic body must be connected with the earth.